Danby SPAC8499 manual Setting the AUTO-OFFTIMER

Setting the AUTO-OFF TIMER

Before setting the AUTO-OFFtimer, the time of day clock must be set/operational.

1)To set the AUTO-OFFtimer, the unit must be turned on (I/O switch) and operational.

2)Press the TIMER-OFFkey pad to initiate the AUTO-OFFtime sequence. Fig. 33. The display

window will indicate TIMER-OFFand the word

OFF will flash for 5 seconds. Press theor key pad to select the desired AUTO-OFFtime. Fig. 33a.

key pad will decrease the AUTO-TIMEDsetting in 10 minute increments.

keypad will increase the AUTO-TIMEDsetting in 10 minute increments.

When the desired time is established, (the time will flash in the display window) press the CLOCK key pad to register the AUTO TIMER- OFF program. The word OFF will stop flashing and remain “on” (TIMER OFF) indicating the program is set. The time of day clock setting will immediately revert back in the display window.

You can varify the AUTO-OFFtime selection anytime by pressing the TIMER-OFFkey pad. The time you selected will appear (flash) temporarily (replacing the time of day) for approximately 5 seconds.

IMPORTANT: The desired AUTO-OFF time must be registered within a 5 second period (after pressing the TIMER-OFF key pad) otherwise the selected time will not register and the system will automatically revert back to the regular “time of day” clock setting. If this occurs, you must repeat step 2 again.

The unit will stop automatically when the specified AUTO-OFFtime is achieved on the time of day clock. To cancel or override the AUTO-TIMEDprogram, simply turn off the unit manually, prior to the scheduled AUTO-OFFtime.

TIMER OFF	12:00	I/O	MODE
			TEMP./CLOCK

ADJ.

FANON

TIMER

SWING OFF CLOCK

Fig. 33

TIMER OFF	12:00	I/O	MODE
				TEMP./CLOCK
				ADJ.
		FAN	ON
			TIMER
		SWING	OFF	CLOCK

Fig. 33a

17