
Symbologies
Standard 2 of 5 — cont.
Standard 2 of 5 Set Length 1
This feature specifies one of the barcode lengths for Standard 2 of 5 Length Control. Length 1 is the minimum label length if in Variable Length Mode, or the first fixed length if in Fixed Length Mode. Length includes the barcode’s check and data charac- ters.
The length can be set from 1 to 50 characters.
Follow these instructions to set this feature:
1.Determine the desired character length (from 1 to 50). Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
3.Scan the barcode: SELECT STANDARD 2 OF 5 LENGTH 1 SETTING.
4.Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent the length setting which was determined in the steps above. You will hear a
If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.
NOTE
5.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See Table 33 for some examples of how to set this feature.
Table 33. Standard 2 of 5 Length 1 Setting Examples
STEP | ACTION |
|
| EXAMPLES |
| |
|
|
|
|
|
| |
1 | Desired Setting | 01 Character |
| 07 Characters | 15 Characters | 50 Characters |
|
|
|
|
|
|
|
2 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
| ||
|
|
|
|
| ||
3 | Scan SELECT STANDARD 2 OF 5 LENGTH 1 SETTING |
|
|
| ||
|
|
|
|
|
|
|
4 | Scan Two Characters From | ‘0’ and ‘1’ |
| ‘0’ and ‘7’ | ‘1’ and ‘5’ | ‘5’ AND ‘0’ |
Appendix E, Keypad |
| |||||
|
|
|
|
|
| |
|
|
|
|
|
|
|
5 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
| ||
|
|
|
|
|
|
|
250 | QuickScan® QD2100 |