Datalogic Scanning QD2100 Label Gone Timeout, Timeout Setting Examples, 005 015, ‘0’, ‘0’ and ‘5’

Label Gone Timeout

Label Gone Timeout

This feature sets the time after the last label segment is seen before the reader prepares for a new label. The timeout can be set within a range of 10 milliseconds to 2,550 millisec- onds (2.55 seconds) in 10ms increments. Label Gone Timeout does not apply to scan modes that require a trigger pull for each label that is read

Follow these instructions to set this feature:

1.Determine the desired setting in milliseconds.

2.Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead- ing zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 = 020, etc.

3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.

4.Scan the barcode: SELECT LABEL GONE TIMEOUT SETTING.

5.Scan the appropriate three alpha-numeric characters from the keypad in Appendix E, Key- pad representing the duration which was determined in the steps above. You will hear a two-beep indication after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.

NOTE

6.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.

This completes the procedure. See Table 2 for some examples of how to set this feature.

Table 2. Timeout Setting Examples

STEP	ACTION			EXAMPLES
1	Desired Setting	50ms	150ms		1800ms (1.8 sec.)	2550ms (2.55 sec.)
2	Divide by 10 (and pad with leading	005	015		180	255
	zeroes)
3	Scan ENTER/EXIT PROGRAMMING MODE
4	Scan SELECT LABEL GONE TIMEOUT SETTING
5	Scan Three Characters From	‘0’, ‘0’ and ‘5’	‘0’, ‘1’ and ‘5’		‘1’, ‘8’ and ‘0’	‘‘2’, ‘5’ and ‘5’
	Appendix E, Keypad
6	Scan ENTER/EXIT PROGRAMMING MODE

Product Reference Guide 19