Datalogic 2 of 5
Datalogic 2 of 5 — cont.
Datalogic 2 of 5 Set Length 1
This feature specifies one of the barcode lengths for Datalogic 2 of 5 Length Control. Length 1 is the minimum label length if in Variable Length Mode, or the first fixed length if in Fixed Length Mode. The length includes the barcode’s check and data char- acters.
The length can be set from 2 to 50 characters in increments of two.
Follow these instructions to set this feature:
1.Determine the desired character length (from 2 to 50). The length must be an even num- ber.
2.Pad the result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
4.Scan the barcode: SELECT I 2 of 5 LENGTH 1 SETTING.
5.Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent the length setting which was determined in the steps above. You will hear a
If you make a mistake before the last character scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.
NOTE
6.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See Table 27 for some examples of how to set this feature.
Table 27. Datalogic 2 of 5 Length 1 Setting Examples
STEP | ACTION |
|
| EXAMPLES |
| |
|
|
|
|
|
|
|
1 | Desired Setting | 2 Characters | 6 Characters |
| 14 Characters | 50 Characters |
|
|
|
|
|
|
|
2 | Pad with leading zeroes to yield | 02 | 06 |
| 14 | 50 |
two digits |
| |||||
|
|
|
|
|
| |
|
|
|
|
|
|
|
3 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
|
| |
|
|
|
|
|
| |
4 | Scan SELECT Datalogic 2 of 5 LENGTH 1 SETTING |
|
|
|
| |
|
|
|
|
|
|
|
5 | Scan Two Characters From | ‘0’ and ‘2’ | ‘0’ and ‘6’ |
| ‘1’ and ‘4’ | ‘5’ AND ‘0’ |
Appendix E, Keypad |
| |||||
|
|
|
|
|
| |
|
|
|
|
|
|
|
6 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
|
| |
|
|
|
|
|
|
|
Product Reference Guide | 205 |
