Flash On Time
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode. The se- lectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond in- crements.
Follow these instructions to set this feature.
1.Determine the desired setting in milliseconds.
2.Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
4.Scan the barcode: SELECT FLASH ON TIME SETTING.
5.Scan the appropriate two digits from the keypad in Appendix E, Keypad representing the duration which was determined in the steps above. You will hear a
If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.
NOTE
6.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See Table 5 for some examples of how to set this feature.
Table 5. Flash On Time Setting Examples
STEP | ACTION |
| EXAMPLES |
| ||
|
|
|
|
|
| |
1 | Desired Setting | 500ms | 1,000ms (1 sec.) | 5200ms (5.2 sec.) | 9,900ms (9.9 sec.) | |
|
|
|
|
|
| |
2 | Divide by 100 (and pad with | 05 | 10 | 52 | 99 | |
leading zeroes to yield two digits) | ||||||
|
|
|
|
| ||
|
|
|
|
|
| |
3 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
| ||
|
|
|
|
| ||
4 | Scan SELECT FLASH OFF TIME SETTING |
|
|
| ||
|
|
|
|
|
| |
5 | Scan Two Characters From | ‘0’ and ‘5’ | ‘1’ and ‘0’ | ‘5’ and ‘2’ | ‘9’ and ‘9’ | |
Appendix E, Keypad | ||||||
|
|
|
|
| ||
|
|
|
|
|
| |
6 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
| ||
|
|
|
|
|
| |
Product Reference Guide | 35 |
