Symbologies
GS1 DataBar Expanded — cont.
GS1 DataBar Expanded Set Length 2
This feature specifies one of the barcode lengths for GS1 DataBar Expanded Length Control. Length 2 is the maximum label length if in Variable Length Mode, or the sec- ond fixed length if in Fixed Length Mode. Length includes the barcode’s data characters only.
The length can be set from 1 to 74 characters. A setting of 0 specifies to ignore this length (only one fixed length).
Follow these instructions to set this feature:
1.Determine the desired character length (from 1 to 74). Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
3.Scan the barcode: SELECT GS1 DataBar EXPANDED LENGTH 2 SETTING.
4.Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent the length setting which was determined in the steps above. You will hear a
If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.
NOTE
5.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See Table 20 for some examples of how to set this feature.
Table 20. GS1 DataBar Expanded Length 2 Setting Examples
STEP | ACTION |
| EXAMPLES |
| ||
|
|
|
|
|
| |
1 | Desired Setting | 00 (ignore second | 07 Characters | 52 Characters | 74 Characters | |
length) | ||||||
|
|
|
|
| ||
|
|
|
|
|
| |
2 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
| ||
|
|
|
| |||
3 | Scan SELECT GS1 DataBar EXPANDED LENGTH 2 SETTING |
|
| |||
|
|
|
|
|
| |
4 | Scan Two Characters From | ‘0’ and ‘0’ | ‘0’ and ‘7’ | ‘5’ and ‘2’ | ‘7’ and ‘4’ | |
Appendix E, Keypad | ||||||
|
|
|
|
| ||
|
|
|
|
|
| |
5 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
| ||
|
|
|
|
|
| |
150 | QuickScan® QD2100 |
