Dell 1526, 1525 owner manual Adding and Replacing Parts, Before You Begin, Recommended Tools, 133

Adding and Replacing Parts

Before You Begin

This chapter provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the following conditions exist:

•You have performed the steps in "Turning Off Your Computer" on page 133 and "Before Working Inside Your Computer" on page 134.

•You have read the safety information in your Dell Product Information Guide.

•A component can be replaced—or if purchased separately—installed by performing the removal procedure in reverse order.

Recommended Tools

The procedures in this document may require the following tools:

•Small flat-blade screwdriver

•Phillips screwdriver

•Small plastic scribe

•Flash BIOS update (see the Dell Support website at support.dell.com)

Turning Off Your Computer

NOTICE: To avoid losing data, save and close any open files and exit any open programs before you turn off your computer.

1Save and close any open files and exit any open programs.

2Click Start , click the arrow , and then click Shut Down.

The computer turns off after the operating system shutdown process finishes.

3Ensure that the computer and any attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut down your operating system, press and hold the power button for at least 8 to 10 seconds until the computer turns off.

Adding and Replacing Parts

133