Dell 610 technical specifications Total Dimm Socket Desired Memory

Total			DIMM Socket
Desired	A	B	C	D
Memory
64 MB	32 MB	32 MB
64 MB	64 MB
96 MB	32 MB	32 MB	32 MB
128 MB	32 MB	32 MB	32 MB	32 MB
192 MB	64 MB	64 MB	32 MB	32 MB
256 MB	128 MB	128 MB
384 MB	64 MB	64 MB	128 MB	128 MB
512 MB	128 MB	128 MB	128 MB	128 MB
Table 9-2. Sample Registered SDRAM DIMM Configuration Options
Total			DIMM Socket
Desired	A	B	C	D
Memory
512 MB	256 MB	256 MB
768 MB	256 MB	256 MB	256 MB
1024 MB	256 MB	256 MB	256 MB	256 MB
2048 MB	512 MB	512 MB	512 MB	512 MB

Follow this procedure to perform a memory upgrade:

1.Remove the computer cover according to the instructions in "Removing the Computer Cover".

CAUTION: See "Protecting Against Electrostatic Discharge".

2.To access the DIMM sockets on the system board, rotate the power supply as described in "Rotating the Power Supply Away From the System Board".

3.Determine the DIMM sockets in which you will install DIMMs or replace existing DIMMs.

4.Install or replace DIMMs as necessary to reach the desired memory total.

Follow the instructions in "Installing a DIMM" or "Removing a DIMM" as appropriate, found later in this section.

5.Rotate the power supply back into position, making sure the securing tab snaps into place.

6.Replace the computer cover, and reconnect your computer and peripherals to their power sources and turn them on.

NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be displayed at the next system start-up:

ALERT! Cover was previously removed.

The system detects that the new memory does not match the existing system configuration information and generates the following message:

The amount of system memory has changed.

Strike the F1 key to continue, F2 to run the setup utility

7.Press <F2> to enter the System Setup program, and check the value for System Memory in the lower-right corner of Page 1.