information on resetting the chassis intrusion detector.
6.In the System Setup program, verify that the password is disabled. Proceed to step 7 if you want to assign a new password.
NOTE: Before you assign a new system and/or setup password, you must replace the PSWD jumper plug.
7.Remove the computer cover according to the instructions in "Removing the Computer Cover".
CAUTION: See "Protecting Against Electrostatic Discharge".
8.Replace the PSWD jumper plug.
9.Replace the computer cover, and then reconnect the computer and peripherals to their power sources and turn them on.
Booting with the PSWD jumper installed reenables the password feature. When you enter the System Setup program, both password options appear as Not Enabled, meaning that the password feature is enabled but that no password has been assigned.
NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be displayed at the next system
ALERT! Cover was previously removed.
10.To reset the chassis intrusion detector, enter the System Setup program and reset Chassis Intrusion to Not Detected. See "Chassis Intrusion" for instructions.
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector.
11.Assign a new system and/or setup password.
To assign a new system password, see "Assigning a System Password". To assign a new setup password, see "Assigning a Setup Password".
Responding to Error Messages
If an error message appears on your monitor screen while the system is booting, make note of the message. Then, before entering the System Setup program, refer to your Diagnostics and Troubleshooting Guide for an explanation of the message and suggestions for correcting any errors. However, it is normal to receive an error message the first time you boot the system after a memory upgrade. In that case, you do not need to refer to the Diagnostics and Troubleshooting Guide; instead, refer to the instructions in "Adding Memory".
If you are given an option of pressing either <F1> to continue or <F2> to run the System Setup program, press the <F2> key.
