Dell C610, C510 manual Removing the Mini PCI Card

Memory Modules, Mini PCI Card, and Modem: Dell Latitude C610/C510 Service Manual

1.If you only have one memory module, install it in the connector labeled "JDIM1" on the system board. Install a second memory module in the connector labeled "JDIM2."

NOTE: Memory modules are keyed, or designed to fit into their sockets, in only one direction.

NOTICE: The memory module must be inserted at a 45-degree angle to avoid damaging the connector.

2.Align the notch in the memory module with the slot in the center of the socket.

3.Slide the edge connector of the module firmly into the socket at a

45-degree angle, and rotate the module down until you hear a click. If you do not hear the click, remove the module and reinstall it.

4.Replace the cover and tighten the two captive screws.

Mini PCI Card

You must remove the Mini PCI card before the system board can be removed.

Removing the Mini PCI Card

NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.

NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure.

1.Remove the memory module cover.

2.Disconnect the Mini PCI card from the antenna cables.

3.To release a Mini PCI card from its socket, spread apart the metal securing tabs until the card pops up slightly.

4.Lift the Mini PCI card out of its connector.

Mini PCI Card

file:///C/Work%20Area%20-%20A/E%20DOC%20Posting/latc610/service%20manual/upgrades.htm[2/1/2013 11:00:44 AM]