Dell SC1435 owner manual System Messages

Table 1-5. Diagnostic Indicator Codes (continued)

Code	Causes	Corrective Action
	BIOS checksum failure	Ensure that all network connections are functioning
	detected; system is in	properly. See ""Troubleshooting Your System" on
	recovery mode.	page 67."
		If the problem persists, see ""Getting Help" on page 95."

System Messages

System messages appear on the screen to notify you of a possible problem with the system. Table 1-6 lists the system messages that can occur and the probable cause and corrective action for each message.

NOTE: If you receive a system message that is not listed in Table 1-6, check the documentation for the application that is running when the message appears or the operating system's documentation for an explanation of the message and recommended action.

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.

Table 1-6. System Messages

Message	Causes	Corrective Actions
Alert! Node Interleaving	The memory configuration does not	Ensure that the memory modules are
disabled! Memory configu-	support node interleaving. The	installed in a configuration that
ration does not support	system will run but with reduced	supports node interleaving. See
	functionality.	"Memory Module Installation
Node Interleaving.
		Guidelines" on page 46. If the problem
		persists, see "Troubleshooting System
		Memory" on page 76.
Attempting to update	Remote Configuration request has	Wait until the process is complete.
Remote Configuration.	been detected and is being
Please wait...	processed.
BIOS Update Attempt	Remote BIOS update attempt	Retry the BIOS update. If problem
Failed!	failed.	persists, see "Getting Help" on page 95.
Caution! NVRAM_CLR jumper	NVRAM_CLR jumper is installed.	Remove the NVRAM_CLR jumper.
is installed on system	CMOS has been cleared.	See Figure 6-1 for jumper location.
board.

16

About Your System