14After an hour, reconnect the system to its electrical outlet and turn it on.
15Enter the System Setup program and if the time and date are still incorrect, see "Getting Help" on page 95 for instructions on obtaining technical assistance.
Control Panel Assembly (Service-Only Procedure)
Removing the Control Panel
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.
1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening and Closing the System" on page 38.
3Disconnect the control panel cable from the control panel board. See Figure
NOTICE: Do not pull on the cable to unseat the connector. Doing so can damage the cable.
aSqueeze the metal tabs on the ends of the cable connector.
bGently work the connector out of the socket.
4Remove the two screws securing the control panel board, and remove the board. See Figure
Installing System Components
61
