Dell SC1435 owner manual Removing and Replacing the Front Bezel, Removing the Bezel Key lock

The system provides space for one optional slimline optical drive. For more information, see "Installing the Optical Drive in the System" on page 54.

The hard-drive bays provide space for one or two 3.5-inch hard drives. The hard drives connect to the SATA controller or the system board, or an optional SAS controller card. For more information, see "Hard Drives" on page 55.

During an installation or troubleshooting procedure, you may be required to change a jumper setting. For more information, see "Jumpers and Connectors" on page 89.

NOTE: There are no hot-pluggable components inside this system.

Removing and Replacing the Front Bezel

The system front panel is enclosed by an optional bezel. To access the optional optical drive, you must remove the bezel.

NOTE: You do not need to remove the front bezel to remove the system cover and access internal components.

1Using the system key, unlock the bezel.

2Press the tab at the left end of the bezel.

3Rotate the left end of the bezel away from the system to release the right end of the bezel.

4Pull the bezel away from the system. See Figure 3-2.

Figure 3-2. Removing the Bezel

1

2

1 key lock 2 bezel

To replace the front bezel, perform the preceding steps in reverse.

Installing System Components

37