Dell T8144 manual Addressing Memory With 4-GB Configurations, Dimm connectors 3

•If you install mixed pairs of DDR2 400-MHz (PC2-3200) and DDR2 533-MHz (PC2-4300) memory, the modules function at the slowest speed installed.

•Be sure to install a single memory module in DIMM connector 1, the connector closest to the processor, before you install modules in the other connectors.

Channel A: matched pair of memory modules in connectors DIMM_1 and DIMM_2 (white securing clips)

Channel B: matched pair of memory modules in connectors DIMM_3 and DIMM_4 (black securing clips)

NOTE: Memory purchased from Dell is covered under your computer warranty.

NOTICE: If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that you may have, even if you purchased the new modules from Dell. If possible, do not pair an original memory module with a new memory module. Otherwise, your computer may not start properly. You should install your original memory modules in pairs either in DIMM connectors 1 and 2 or

DIMM connectors 3 and 4.

Addressing Memory With 4-GB Configurations

Your computer supports a maximum of 4 GB of memory when you use four 1-GB DIMMs. Current operating systems, such as Microsoft® Windows® XP, can only use a maximum of 4 GB of address space; however, the amount of memory available to the operating system is less than 4 GB. Certain components within the computer require address space in the 4-GB range. Any address space reserved for these components cannot be used by computer memory.

Removing and Installing Parts

63