Dell T8144 manual Removing Memory

5Insert the module into the connector until the module snaps into position.

If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.

6Replace the computer cover.

NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.

7Connect your computer and devices to electrical outlets, and turn them on.

8Right-click the My Computer icon and click Properties.

9Click the General tab.

10To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Removing Memory

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

1Follow the procedures in "Before You Begin" on page 53.

2Press out the securing clip at each end of the memory module connector.

3Grasp the module and pull up.

If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.

Removing and Installing Parts

65