11.Position table board (R) Fig. 45, on top of angle brackets (N) as shown.
12.While holding table board (R) Fig. 45, tightly against extension wing (K), fasten table (R) to brackets (N) Fig. 45, from underneath the table using three #8 x 7/8
13.Using a straight edge (S) Fig. 46, make certain the Unifence table surface is level with the saw table by placing a square (S) Fig. 46 on the table board and the extension wing, and then adjust the brackets (N) Fig. 45, and then tighten nuts (P) Fig. 45. Place a 3 ft. long level across the table and adjust the two leveling screws located on the bottom of table legs. IMPORTANT: Front edge of Unifence table must be flush with or slightly behind front edge of saw table.
S
Fig. 46
ASSEMBLING UNIFENCE SHELF BOARD
1.Insert one end of table board (A) Fig. 47A, into the motor cover slot (B).
2.Fasten the other end of the shelf board to the shelf support bracket (B) Fig. 36, that was mounted to the table legs earlier with two
ADJUST THE SHELF SUPPORT BRACKET SO THAT THE SHELF IS LEVEL.
ASSEMBLING UNIFENCE GUIDE RAIL TO TABLE
1.Locate the Guide Rail and mounting hardware from the packing material of the Unifence.
2.The guide rail has end caps inserted into each end of the rail. Remove the end cap (B) Fig. 48, by inserting a flathead screwdriver (C) into the channel in the guide rail and press outward against the inside of the end cap (B) as shown. The end cap (B) will pop out. NOTE: Do not attempt to remove the end cap by forcing the screwdriver between the end cap and the end of the rail. This will damage both the cap and the rail.
R
N 
K
Fig. 45
Q |
N |
P |
Fig. 47
B
A
Fig. 47A
C 
B
Fig. 48
16
