Delta 36-841 Commercial Biesemeyer Fence System, Assembling Blade Tilting Mechanism Handle

50" COMMERCIAL BIESEMEYER FENCE SYSTEM

NOTE: A common hardware package is used for several different models, therefore you may have leftover hardware. Fig. 4

1 - Rear Rail

2 - Front Rail

3 - Guide Tube

4 - T-Square®Fence Assembly

5 - Cable Strap

6 - Template for aligning front rail to saw table

for fastening front and rear rails to right extension table Fig. 4

7 - 1-1/2" long flat head Phillips screws (12) 8 - 1-1/4" O.D. Flat Washers (12)

9 - 1/4-20 hex nuts (12)

for fastening rear rail to saw table Fig. 4

10 - 3/8-24 x 1-1/4" long hex head cap screws (2) 11 - 7/8" O.D. flat washers (2)

12 - Lock washers (2)

for fastening front rail to saw table Fig. 4

13 - 3/8-16 x 1-1/4" long flat head Phillips screws (2) 14 - 7/8" O.D. flat washers (2)

15 - Lock washers (2)

16 - 3/8-16 hex nuts (2)

for fastening guide tube to front rail Fig. 4 17 - 1/2 long hex screws (9)

18 - Lock washers (9)

leg hardware Fig. 5 19 - Legs (2)

20 - 5/8" long wood screws #8 (8)

21 - 1/4-20 x 1-1/2" long flat head phillips screws (4) 22 - 1/4" flat washers (4)

23 - 1/4-20 hex nuts (4)

1

2 3

17		18
4	13 15		6
		10
	14		12
	16	11
		7	5
		8
			9
	Fig. 4

19

21

23

22

20

Fig. 5

LIMITED EDITION UNISAW ASSEMBLY

INSTRUCTIONS

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE SAW TO THE POWER SOURCE UNTIL THE SAW IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

ASSEMBLING BLADE

TILTING MECHANISM

HANDLE

1.Install fiber washer (A) Fig. 6A, on the blade tilting mechanism shaft (B). Install key (C), into shaft keyway.

2.Place handwheel (D) on shaft (B) Fig. 6A. Make sure the groove (E), in the handwheel lines up with the key (C).

3.Push the handwheel snugly against the fiber washer and tighten the set screw.

E

A

B

D

C

Fig. 6A

8