C
B
D
Fig. 97
ASSEMBLING GUIDE TUBE TO FRONT RAIL
1.Lay the guide tube (B) Fig. 97, on the saw table as shown, and line up the threaded holes (C) on bottom of guide tube (B) with the through holes (D) on the front rail (A).
2.Position the guide tube (B) Fig. 98, on the front rail and fasten the guide tube to the rail using the 1/2" long hex screws (G) and lockwashers in all of the holes.
FENCE OPERATION
IMPORTANT: Before operating fence, make sure the fence is adjusted parallel to the miter gage slot, as explained later on in this manual.
1.To place the fence on the guide rail, lift up clamp (A) Fig. 50, and place the fence over the rail and gently push fence onto rail (B) Fig. 99.
2.To move the fence along the guide rail, lift up clamp lever (A) as shown in Fig. 99, slide fence to desired position on rail, and push down on clamp lever (A) as shown in Fig. 100, to lock fence in position. NOTE: A magnet (B) Fig. 100, is provided to hold clamp handle (A) in the up position when moving the fence.
3.The distance the fence is positioned away from the blade is indicated by the witness line (C) Fig. 101, located on the cursor (D). If it is necessary to adjust the cursor (D), make a test cut with the fence locked in position. Measure the width of the finished cut and adjust the cursor (D) by loosening the two screws (E), adjusting the cursor (D) until the witness line (C) is aligned with the same marking on the scale as the finished cut. Then tighten the two screws (E).
B
G
Fig. 98
A
Fig. 99
B
A
Fig. 100
E
B
D
C
Fig. 101
27
