Y
X
Z
Fig. 23
11.Reassemble the saw blade, making certain the teeth are pointing down at the front of the saw table as shown in Fig. 23, and assemble the outside blade flange and arbor nut (X). With open end wrench (Y) on the flats of the arbor to keep it from turning, tighten arbor nut by turning box end wrench (Z) counterclockwise.
12.Using a straight edge (A) Fig. 24, make certain the splitter (P) is aligned with the saw blade (B). Using a square (C) Figs. 25 and 26, make certain saw blade (B) Fig. 25, and splitter (P) Fig. 26, are 90 degrees to the table surface. Once you are certain the splitter is aligned to the saw blade and table, tighten all splitter mounting hardware (D) Fig. 26 and recheck alignment.
13.Holding the clear blade guard, lower the saw blade and assemble the table insert (E) Fig. 27, into the opening on the saw table.
P
D
Fig. 26
FASTENING MOTOR CORD TO SAW FRAME
1.IMPORTANT: Turn the blade tilting handwheel counterclockwise as far as it will go until the saw blade is in the 45 degree position.
2.IMPORTANT: Turn the blade raising and lowering handwheel counterclockwise until the blade is at its lowest position.
3.Fasten motor cord (A) Fig. 27A to the saw frame cross member (B), using the cable tie (C) supplied with the saw. CAUTION: Before tightening the cable tie, make certain that cord (A) is free of any interference from the motor or saw blade at all possible positions of the motor.
4.After the cable tie is tightened, cut off excess tail of cable tie (C) Fig. 27A.
P
A
B
Fig. 24
B
Fig. 25
E
Fig. 27
A
B
C
Fig. 27A
12
