Denon AV Surround Receiver, AVR-1612 NOTE, ENTER, Examples, Measures, Information, Error details, version Basic, version Advanced, Set up speakers (Audyssey® Auto Setup)

Set up speakers (Audyssey® Auto Setup)

Error messages

NOTE

•An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey® Auto Setup over again.

•If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker connections and repeat the measurement process from the beginning.

•Be sure to turn off the power before checking speaker connections.

Examples		Error details	Measures
		• The connected setup microphone is broken, or a device other than the	• Connect the included setup microphone to the SETUP MIC jack of this unit.
Audyssey Auto Setup	MultEQ
		supplied setup microphone is connected.
Caution!			• Check the speaker connections.
		• Not all speakers could be detected.
Microphone or Speaker is none
		• The front L speaker was not properly detected.
Retry
Audyssey Auto Setup	MultEQ	• There is too much noise in the room for accurate measurements to be	• Either turn off any device generating noise or move it away.
		made.	• Perform again when the surroundings are quieter.
Caution!
		• Speaker or subwoofer sound is too low for accurate measurements to be	• Check the speaker installation and the direction in which the speakers are
Ambient noise is too high or Level is too low		made.	facing.
			• Adjust the subwoofer’s volume.
Retry
Audyssey Auto Setup	MultEQ	• The displayed speaker could not be detected.	• Check the connections of the displayed speaker.
		(The screen on the left indicates that the front right speaker cannot be
Caution! Speaker:None
		detected.)
Front R
Retry
Audyssey Auto Setup	MultEQ	• The displayed speaker is connected with the polarity reversed.	• Check the polarity of the displayed speaker.
		(The screen on the left indicates that the polarity phases of the front right	• For some speakers, this error message may be
Caution! Speaker:Phase
		speakers are reversed.)	displayed even if the speaker is properly connected.
Front R			If you are sure the connection is correct, press ui
Skip			to select “Skip”, then press ENTER.
Retry

version Basic

version Advanced

Information

16