System Setup

Setting items

Setting details

 

 

Channel Level

Test Tone Start : Output test tone.

Set the volume of the test

• Front L / F.Height L / Center / F.Height R / Front R / Surround R /

tone to be the same when it S.Back Rz / S.Back Lz / Surround L / Subwoofer : Select the speaker. is output from each speaker. zz When the “Speaker Config.” – “S.Back” setting (vpage 59) is set

to “1spkr”, “S.Back” is displayed.

•–12.0dB – +12.0dB (0.0dB) : Adjust the volume.

When “Channel Level” is adjusted, the adjusted values are set for all the surround modes. To adjust the channel level separately for the different surround modes, use the operation see page 44.

NOTE

•Speakers set to “None” in the “Speaker Config.” (vpage 59) settings are not displayed.

•When a headphones jack is inserted in the PHONES jack of this unit, the “Channel Level” is not displayed.

Default : The “Channel Level” settings are returned to the default settings.

•Yes : Reset to the defaults.

•No : Do not reset to the defaults.

When you select “Default” and press ENTER, the “Return settings to the default?” prompt

is displayed. Select either “Yes” or “No”, and press ENTER.

BD

61

Setting items

Setting details

 

 

Crossover Freq.

Crossover : Set the crossover frequency.

Set the maximum frequency • 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /

of the bass signal output

250Hz

 

 

from each channel to

Advanced : Specify crossover frequency for each speaker.

the subwoofer. Set the

• Front / Center / Surround

/ S.Back

/ F.Height : Select the speaker.

Crossover Frequency to

• 40Hz / 60Hz / 80Hz / 90Hz

/ 100Hz

/ 110Hz / 120Hz / 150Hz / 200Hz /

suit the bass reproduction

capability of the speaker

250Hz : Set the crossover frequency.

 

 

 

being used.

 

 

 

 

• “Crossover Freq.” can be set when the “Bass Setting” – “Subwoofer

 

Mode” (vpage 60) setting is “LFE+Main”, or when you have a

 

speaker that is set to “Small”.

 

• Always set the crossover frequency to “80Hz”. When using small

 

speakers, however, we recommend setting the crossover frequency to

 

a higher frequency.

 

• For speakers set to “Small”, sound below the crossover frequency

 

is cut from the sound output. The cut bass sound is output from the

 

subwoofer or front speakers.

 

• The speakers that can be set when “Advanced” is selected differ

 

depending on to the “Subwoofer Mode” setting (vpage 60).

 

• When “LFE” is selected, speakers set to “Small” at “Speaker Config.”

 

can be set. If the speakers are set to “Large”, “Full Band” is displayed

 

and the setting cannot be made.

 

• If set to “LFE+Main”, this setting can be made regardless of the

 

speaker size.

 

vSee overleaf

 

 

 

 

version Basic

version Advanced

Information