Tone

Adjust the tonal quality of the sound.

Setting items

Setting details

 

 

Tone Control

ON : Allow tone adjustment (bass, treble).

Set the tone control function OFF : Playback without tone adjustment.

to ON and OFF.

“Tone Control” can be set when “Dynamic EQ®” (vpage 55) is

 

 

set to “OFF”.

NOTE

The tone cannot be adjusted in the “DIRECT” mode.

Bass

–6dB – +6dB

Adjust low frequency range

“Bass” can be set when “Tone Control” is set to “ON”.

(bass).

 

Treble

–6dB – +6dB

Adjust high frequency range

 

(treble).

“Treble” can be set when “Tone Control” is set to “ON”.

 

 

Audio Adjust

Audyssey Settings

Default settings are underlined.

Set Audyssey MultEQ®, Audyssey Dynamic EQ® and Audyssey Dynamic Volume®. These can be selected after Audyssey® Auto Setup has been performed. For additional information on Audyssey technology, please see page 89.

NOTE

•If you have not performed Auto Setup, or if you change the speaker settings after performing Auto Setup, you may not be able to select Dynamic EQ®/Dynamic Volume®.

In this case, either perform Audyssey® Auto Setup over again or perform “Restore” (vpage 17) to return to the settings after Audyssey® Auto Setup was run.

•When HD Audio for which the sampling frequency exceeds 96 kHz is played back, the “Audyssey Settings” cannot be set.

Setting items

Setting details

 

 

 

 

 

 

MultEQ®

Audyssey : Optimize the frequency response of all speakers.

MultEQ® corrects both time

Audyssey Byp.L/R : Optimize frequency response of speakers except

and frequency response

front L and R speakers.

problems in the listening

Audyssey Flat : Optimize frequency response of all speakers to flat

area based on Audyssey®

response.

Auto Setup calibration. We

Manual : Apply frequency response set with “Manual EQ” (vpage 55).

recommend “Audyssey”.

OFF : Turn “MultEQ®” equalizer off.

MultEQ® is the prerequisite

 

 

 

 

 

function for Dynamic EQ®

• “Audyssey”, “Audyssey Byp. L/R” and “Audyssey Flat” can be selected

and Dynamic Volume®.

 

after Audyssey® Auto Setup has been performed. “Audyssey” is

 

automatically selected after performing Audyssey® Auto Setup. When

 

“Audyssey”, “Audyssey Byp. L/R” or “Audyssey Flat” is selected,

 

 

 

 

 

illuminates.

 

 

 

 

 

 

 

 

 

 

• After running Audyssey® Auto Setup, if the Speaker Configuration,

 

Distance, Channel Level, and Crossover Frequency have changed

 

without increasing the number of speakers measured, only

 

 

 

 

 

illuminates.

version Basic

version Advanced

Information

NOTE

• “MultEQ®” and “Manual” cannot be selected when “EQ Customize” is set to “Not Used” (vpage 63).

• When using headphones, “MultEQ®” is automatically set to “OFF”.

“MultEQ®”, “Dynamic EQ®” and “Dynamic Volume®” settings are stored for each input source.

vSee overleaf

BD

54