Set up speakers

around items indicate the settings.

Here we describe how to set up speakers other than 5.1-channel speakers.

 

For the method of setting up 5.1-channel speakers, see C page 4 “Setup wizard”.

 

First install and connect the speakers to this unit.

Before Auto Setup measurement, the settings shown below can be made.

•Changing the amplifier assignment (Pre Assign)

The signal output from the SURR.BACK/FRONT HEIGHT terminals on PRE OUT of the amplifier can be switched in accordance with the speaker environment (vpage 40 “Set up “Pre Assign””).

•Setting the channels to be used (Channel Select)

If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage 41 “Set up “Channel Select””).

version Basic

1

Set up the

 

remote control unit

nn Set up the operation mode

Press AMP to set the remote control unit to AMP- operation mode.

Press AMP

2 Connect the setup microphone.

When the setup microphone is connected, the following screen is displayed.

Audyssey Auto Setup

MultEQ

Preparation

 

Connect the speakers and place them according to the recommendations in the manual.

Next

[ENTER] Enter

[RETURN] Cancel

3 Select “Next”, and then press

ENTER.

4

Set up “Pre Assign”
Use ui to select “Pre Assign”, and then press

ENTER.

Audyssey Auto Setup

MultEQ

Preparation

Set the following items if necessary.

Pre Assign

Channel Select

Auto Setup Start

[ENTER] Enter

[RETURN] Cancel

Pre Assign

 

MultEQ

 

 

 

 

Pre Assign

NORMAL

 

 

 

 

 

 

version Advanced

Information

[RETURN] Cancel

vSee overleaf

BD

40