1

Set up the microphone

 

Mount the setup microphone on a tripod or stand and place it in the main listening position.

When placing the setup microphone, adjust the height of the sound receptor to the level of the listener’s ear.

Sound receptor

Setup microphone

If you do not have a tripod or stand, set up the microphone on, for example, a seat without a back.

NOTE

•Do not hold the setup microphone in your hand during measurements.

•Avoid placing the setup microphone close to a seat back or wall as sound reflections may give inaccurate results.

2

Set up the subwoofer

If using a subwoofer capable of the following adjustments, set up the subwoofer as shown below.

nn When using a subwoofer with a direct mode

Set the direct mode to “On” and disable the volume adjustment and crossover frequency setting.

nn When using a subwoofer without a direct mode

Make the following settings:

•Volume : “12 o’clock position”

•Crossover frequency : “Maximum/Highest Frequency”

•Low pass filter : “Off”

•Standby mode : “Off”

NOTE

When you use two subwoofers, please adjust the subwoofer volume controls individually so that each subwoofer level is as close as possible to 75 dB using the test tone (vpage 104) before Audyssey® Auto Setup.

 

Set up speakers (Audyssey® Auto Setup)

3

Set up the remote control unit

nn Set up the zone mode

Press ZONE SELECT to switch the zone mode to J(MAIN ZONE).

The J indicator lights.

Press ZONE SELECT

nn Set up the operation mode

Press AMP to set the remote control unit to AMP- operation mode.

Press AMP

vSee overleaf

version Basic

version Advanced

Information

20