Denon AVR-2312CI Set up “Channel Select”

Use opto select the	6
4 configuration of the connected	6	Set up “Channel Select”
speakers.		Use ui to select “Channel Select”, and then press

ENTER.

Set up speakers

7 Use uito select a channel.

Front Select for setting the front speakers to be used. In this case, go to step 8.

• “Front” can be set when “Amp Assign” is set to

version Basic

NORMAL Select the “NORMAL” setting to perform 7.2-channel playback using the surround back or front height speakers.

ZONE2 Select the “ZONE2” setting to assign the unit’s builtin power amplifier for ZONE2 and output the audio in stereo.

Bi-AMPSelect the “Bi-AMP” setting to connect the front speakers via the bi-amp connection.

2CH When you perform 2-channel playback in the DIRECT or STEREO mode, select the “2CH” setting to use the other front speakers for playback.

Front B Select the “Front B” setting to use the second set of front speakers for playback.

F.Height Select the “F.Height” setting to use the front height speaker for playback.

5 Press RETURN Bto exit the “Amp Assign” setting.

AUDYSSEY AUTO SETUP

STEP1 Preparation		1 2 3	4 5 6
Connect the speakers and place them according
to the recommendations in the manual,
Set the following items
If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter	RETURN	Cancel

Enable skip of measuring unused channels to reduce time

AUDYSSEY AUTO SETUP

STEP1 Preparation	Channel Select			1 2 3 4 5 6
STEP1 Preparation				1 2 3 4 5 6
ConnectSubwooferthe sp akers and place thMeasurem according
to the recommendations in the manual,
Set the following items
If necessary.
Amp Assign
Channel Select
Measure subwoofer channel
Auto Setup Start	Enter			Cancel
	Enter	RETURN		Cancel
	Enter	RETURN	Cancel

Enable skip of measuring unused channels to reduce time

“Front B”.

Subwoofer Select for no subwoofers to be used. In this case, go to step 9.

Surround Select the number of surround back speakers to be

Back used. In this case, go to step 10.

•“Surround Back” can be set when “Amp Assign” is set to “NORMAL”.

Front Select for no front height speakers to be used. In this Height case, go to step 11.

•“Front Height” can be set when “Amp Assign” is set to “F.Height”.

8 Press opto select a front speaker.

ASelect this to use front speaker A.

BSelect this to use front speaker B.

A+B Select this to use front speakers A and B simultaneously.

vSee overleaf

version Advanced

Information