STEP 1

Preparation

Set up speakers (Audyssey® Auto Setup)

STEP 2

Detection & Measurement (Main)

version Basic

4 Connect the setup microphone to the SETUP MIC jack of this unit.

When the setup microphone is connected, the following screen is displayed.

AUDYSSEY AUTO SETUP

STEP1 Preparation

1 2 3 4 5 6

Connect the speakers and place them according to the recommendations in the manual.

Set the following items If necessary.

Amp Assign

Channel Select

Auto Setup Start

•In STEP 2, you will perform measurements at the main listening position.

•This step automatically checks the speaker configuration and speaker size, and calculates the channel level, distance, and crossover frequency.

It also corrects distortion in the listening area.

6 Select “Measure” and then press ENTER.

When measuring begins, a test tone is output from each speaker.

•Measurement requires several minutes.

7 The detected speakers are displayed.

•The illustration below shows an example of when the front speakers, center speaker, subwoofer, and surround speakers have been detected.

AUDYSSEY AUTO SETUP

STEP2 Speaker Detection Check

1 2 3 4 5 6

Front

Yes

 

Center

Yes

 

Subwoofer

Yes

 

NOTE

If “Caution!” is displayed:

Go to “Error messages” (vpage 24), check any related items, and perform the necessary procedures.

If the problem is resolved, return and restart “Audyssey® Auto Setup”.

When performing Audyssey® Auto Setup over again

Press ui to select “Retry”, and then press ENTER.

When measuring has stopped

qPress RETURN B, to the “Cancel auto setup?” prompt is displayed.

wPress o to select “Yes”, then press ENTER.

Setting up the speakers again

Repeat the operation from step 4 of STEP 1 Preparation .

version Advanced

Information

Start Auto Setup

Enter RETURN Cancel

Surround

Yes

Retry

vSee overleaf

Here, we explain setup using the example of 5.1-channel speaker

playback.

For settings other than 5.1-channel surround, select “Amp Assign” and perform step 4 and 5 of “Set up “Amp Assign”” (vpage 65). If unused channels are set with “Channel Select”, measuring time can be shortened. For setting, perform steps 6 to 11 of “Set up “Channel Select”” (vpage 66).

5 Use i to select “Auto Setup

Start” and then press ENTER.

Next Measurement

Enter RETURN Cancel

Proceed to next after checking speaker connection result

NOTE

If a connected speaker is not displayed, the speaker may not be connected correctly. Check the speaker connection.

8 Use i to select “Next → Measurement” and then press ENTER.

21