Denon AVR-2802/982 Playback using the external input EXT. in jacks, After starting playback

ENGLISH

Playback using the external input (EXT. IN) jacks

1	Set the external input (EXT.
	EXT.IN
	IN) mode.	EXT.IN
	Press the EXT. IN to switch
	the external input.
	(Main unit)	(Remote control unit)

Once this is selected, the input signals connected to the FL (front left), FR (front right) and C (center) channels of the EXT. IN jacks are output directly to the front (left and right) and center speaker systems as well as the pre-out jacks without passing through the surround circuitry.

In addition, the signal input to the SW (subwoofer) jack is output to the PRE OUT SUBWOOFER jack.

2	Cancelling the external input mode
	To cancel the external input (EXT. IN) setting, press the INPUT
	MODE (AUTO, PCM, DTS) or ANALOG button to switch to
	the desired input mode. (See page 36.)
	INPUT MODE ANALOG
	INPUT MODE ANALOG

(Main unit) (Remote control unit)

•When the input mode is set to the external input (EXT. IN), the play mode (DIRECT, STEREO, DOLBY/DTS SURROUND, 5CH/6CH STEREO or DSP SIMULATION) cannot be set.

B

2	1
VOLUME		DISC SKIP+
	DOLBY / DTS
SPEAKER	SURROUND	DIRECT
DSP SIMULATION	5CH / 6CH STEREO	STEREO
		MASTER VOL.
INPUT MODE	ANALOG	EXT.IN

2	AUDIO	TAPE	CDR/MD		1
		CD	MULTI	MUTING

AVR/AVC	VIDEO	DVD	TV
		VDP	VCR
		SYSTEM	SURROUND
TUNING		SETUP	PARAMETER
		TITLE	MENU/GUIDE

BAND

	CH SELECT
MODE	ENTER

SELECT

NOTES:

•In play modes other than the external input mode, the signals connected to these jacks cannot be played. In addition, signals cannot be output from channels not connected to the input jacks.

•The external input mode can be set for any input source. To watch video while listening to sound, select the input source to which the video signal is connected, then set this mode.

After starting playback

[1] Adjusting the sound quality (tone)

The tone control function will not work in the direct mode.

1	The tone switches as follows each time the TONE CONTROL
	button is pressed.

B

TONE

CONTROL

BASS 1

(Main unit)

1TREBLE

2	With the name of the volume to be		SELECT		3	2 1
	adjusted selected, turn the SELECT
	knob to adjust the level.
			(Main unit)	3	If you do not want the bass and treble to be adjusted, turn on
					the tone defeat mode.
	•	To increase the bass or treble: Turn the control clockwise.
		(The bass or treble sound can be increased to up to +12 dB			TONE DEFEAT
		in steps of 2 dB.)			The signals do not pass through the
	•	To decrease the bass or treble: Turn the control clockwise.			bass and treble adjustment circuits,
		(The bass or treble sound can be decreased to up to –12 dB			providing higher quality sound.
		in steps of 2 dB.)

38