Denon AVR-2802/982 Englis, Listening over headphones, Turning the sound off temporarily muting

ENGLIS

[2] Listening over headphones

1	Connect the headphones to the	NOTE:
	PHONES jack of the front panel.	PHONES
		To prevent hearing loss, do not raise the volume level excessively

when using headphones.

1 B

2	Press the SPEAKER A or B to turn the
	speaker off.
	• The output to the speaker and pre-out
	jacks is turned off and no sound is	2
	produced from the speakers.
		(Main unit)

[3] Turning the sound off temporarily (muting)

1	Use this to turn off the audio output
	temporarily.
	Press the MUTING button.
	Cancelling MUTING mode.

•Press the MUTING button again.

MUTING

(Remote control unit)

	DOLBY / DTS
SPEAKER	SURROUND	DIRECT
DSP SIMULATION	5CH / 6CH STEREO	STEREO
		MASTER VOL.
INPUT MODE	ANALOG	EXT.IN

AUDIO		TAPE	CDR/MD
		CD	MULTI	MUTING
AVR/AVC	VIDEO	DVD	TV
		VDP	VCR

1

[4] Combining the currently playing sound with the desired image

1	Simulcast playback	VIDEO SELECT
	Use this switch to monitor a video

source other than the audio source. Press the VIDEO SELECT button repeatedly until the desired source

B

appears on the display. Cancelling simulcast playback.

(Main unit)

•Select “SOURCE” using the video select button.

•Switch the program source to the component connected to the video input.

[5]Checking the currently playing program source, etc.

1

1	On screen display
	• Each time an operation is performed,
	a description of that operation
	appears on the display connected to
	the unit’s VIDEO MONITOR OUT
	jack. Also, the unit’s operating status
	can be checked during playback by
	pressing the remote control unit’s ON
	SCREEN button.
	Such information as the position of
	the input selector and the surround
	parameter settings is output in
	sequence.

ON SCREEN

RETURN

(Remote control unit)

	SYSTEM	SURROUND
TUNING	SETUP	PARAMETER
BAND	TITLE	MENU/GUIDE
		CH SELECT
MODE		ENTER
		SELECT	1
MEMORY	STATUS	ON SCREEN
	DISPLAY	RETURN
USE/LEARN T.TONE	MULTI	DVD	1
		SET UP

1

Using the dimmer function

• Use this to change the brightness of the display.

DIMMER

Front panel display

•Descriptions of the unit’s operations are also displayed on the front panel display. In addition, the display can be switched to check the unit’s operating status while playing a source by pressing the STATUS button.

STATUS

STATUS

DISPLAY

(Main unit) (Remote control unit)

The display brightness changes in four steps

(bright, medium, dim and off) by pressing the

remote control unit’s DIMMER button repeatedly.

The brightness changes in 3 steps each time the button is pressed, and finally the display turns off.

(Main unit)

39