Recalling preset stations
•To call out out preset stations from the remote control unit.
1 |
| Watching the display, press the |
|
| |
| SHIFT | SHIFT button to select the preset |
|
| |
|
| memory block. |
| (Remote control unit) |
|
2 |
| Watching the display, press the |
| CHANNEL + (UP) or – (DOWN) | |
CHANNEL | button to select the desired preset | |
|
|
channel.
(Remote control unit)
•Calling out preset stations from the main unit‘s panel.
1 | TUNING | Press the TUNING PRESET button. |
| ||
| PRESET |
|
(Main unit)
2 | Turn the FUNCTION knob and |
| FUNCTION |
| select the desired station. |
(Main unit)
ENGLIS
| START | LEARNED/TX |
| |
SYSTEM CALL | POWER |
| ||
SET | CALL | OFF | ON / SOURCE |
|
DVD | VDP | TUNER | SHIFT | 1 |
1 | 2 | 3 |
| |
TV/DBS |
| PHONO |
|
|
4 | 5 | 6 |
| 2 |
CD | CDR / TAPE | CHANNEL | ||
7 | 8 | 9 |
| |
|
| TV/VCR |
| |
+10 | 0 |
| A / B |
|
VOLUME |
| DISC SKIP+ |
| |
| DOLBY / DTS |
|
|
|
SPEAKER | SURROUND | DIRECT |
|
|
DSP SIMULATION | 5CH / 6CH STEREO | STEREO |
|
|
|
|
| MASTER VOL. |
|
INPUT MODE | ANALOG | EXT.IN |
|
|
AUDIO |
| TAPE | CDR/MD |
|
| CD | MULTI | MUTING | |
AVR/AVC | VIDEO | DVD | TV |
|
|
| VDP | VCR |
|
| SYSTEM | SURROUND |
TUNING | SETUP | PARAMETER |
BAND | TITLE | MENU/GUIDE |
|
| |
|
| CH SELECT |
MODE |
| ENTER |
|
| |
|
| SELECT |
MEMORY | STATUS | ON SCREEN |
| DISPLAY | RETURN |
USE/LEARN T.TONE | MULTI | SET UP |
1 2
B
13LAST FUNCTION MEMORY
•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
•The unit is also equipped with a
14INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.
1 | Switch off the unit and remove the AC cord from the wall |
outlet. | |
2 | Hold the following A button and B button, and plug the AC |
cord into the outlet. | |
|
|
3 | Check that the entire display is flashing with an interval of |
|
about 1 second, and release your fingers from the 2 buttons and the microprocessor will be initialized.
NOTES:
•If step 3 does not work, start over from step 1.
•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).
B
2
55
