Denon AVR-4802 manual Before setting up the system, 4, 7, 2, 5, 6, 7, 2

Before setting up the system

1	ON / STANDBY	Check that all the connections	are	1
		correct, then turn on the main unit’s
		power.
2	(Main unit)
	Either lightly press on the remote control unit’s touch panel
	or press the LIGHT button to turn on the liquid crystal display.
	(The back light does not turn on when the touch panel is
	pressed.)

3	By default the liquid crystal display is set to display for 30
	seconds, but this can be changed to approximately 120	4, 7, 8
	seconds using the procedure described below so that

operations during system up can be performed securely.

2, 5, 6, 7, 8

2

4	Lightly press the remote control unit’s
	jog stick (PUSH ENTER) to display the
	icon display section.

8	Press the “	” button in the icon display section to display
	the “AVAMP” icon.

Press the “AVAMP” icon to display the page section.

5	Press the “	” button in the icon display section to display
	the “SETUP” icon.

Push the remote control unit’s jog stick to the right to display the “SETUP 3/5” page.

6	Press the “SETUP” icon for at least 3 seconds to display	Press “SYSTEM SETUP” at the bottom left to display the
	the setup screen.
		“System Setup Menu” on the TV screen.

7	Push the remote control unit’s jog
	stick to the right to display the “SETUP
	4/4” page.

Press the “LCD 30s” button on this page so that this part is displayed in half-tone dot mesh.

Now press the “•” button to set the time display to “120s”.

18