Denon AVR-4802 manual Surround, Before playing with the surround function, 1, 3 2, Main Unit

10 SURROUND

Before playing with the surround function

•Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup (see page 26) or from the remote control unit, as described below.

•Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and only effective in the DOLBY SURROUND and HOME THX CINEMA modes. The adjusted levels for the different modes are automatically stored in the memory.

2

1 Press the TEST TONE button.

1, 3 2, 3

2	Test tones are output from the different speakers. Press the
	CURSOR/PAGE button to highlight the display, then use the

jog stick to adjust the channel level.

After completing the adjustment, press the CURSOR/PAGE

3 button again so that the display is no longer highlighted, then press the TEST TONE button to complete the operation.

•After adjusting using the test tones, make the desired settings for each surround mode to be played, then use the procedure described below to adjust the levels of the various channels.

1	MAIN UNIT:
	Press the CH VOL button and select

“CH VOL”.

REMOTE CONTROL UNIT:

Press the CH. SELECT button on the “SURROUND 2/5” page. “CH VOL” is selected.

CH VOL

(Main unit)

(Remote control unit)

1 2

The setting mode switches in the following order each time the button is pressed:

	FL	C	FR	SR	SBR	SBL
		FADER		SW	SL
2	MAIN UNIT:					SELECT
	Turn the SELECT knob to adjust the
	level of the selected speaker.
						(Main unit)
	REMOTE CONTROL UNIT:
	Press the CURSOR/PAGE button on the
	“SURROUND 2/5” page to highlight the
	display. The channel (speaker) switches as
	shown on the diagram below each time it
	is pressed.				(Remote control unit)
	REMOTE CONTROL UNIT:
	Move jog stick “ENTER” back and forth
	to adjust the level of the selected speaker.

2	1, 3
	2

When the surround back speaker setting is set to “1spkr” for “Speaker Configuration”, this is set to “SB”.

(Remote control unit)

42