Denon AVR-4802 manual 1-q 1-e 1-e 1-w, Listening over headphones, Switching the surround speakers

(Remote control unit)

3	If you do not want the bass and treble to be	TONE
	adjusted, turn on the tone defeat mode.
		DEFEAT
	The signals do not pass through the bass

and treble adjustment circuits, providing higher quality sound.

(Main unit)

[2] Listening over headphones

Plug the headphones’ plug into the jack.

Connect the headphones to the PHONES jack.

The pre-out output (including the speaker output) is automatically turned off when headphones are connected.

NOTE:

To prevent hearing loss, do not raise the volume level excessively when using headphones.

[3] Turning the sound off temporarily (muting)

1

1	Use this to turn off the audio output
	temporarily.
	Press the MUTE button.
	Cancelling MUTING mode.
	Press the MUTE button again.	(Remote control unit)

[4] Combining the currently playing sound with the desired image

1

1	Simulcast playback
	Use this switch to monitor a video source other than the audio
	source.

Press the VIDEO SELECT button until the desired image appears.

Cancelling simulcast playback.

VIDEO

SELECT

[5] Checking the currently playing program source, etc.

1-q1-e

1-e1-w

1 q On screen display

•Each time an operation is performed,

a description of that operation appears on the display connected to the unit’s VIDEO MONITOR OUT

jack. Also, the unit’s operating status can be checked during playback by

pressing the remote control unit’s ON SCREEN button. Such information as the position of the input selector and the surround parameter settings is output in sequence.

wFront panel display

• Descriptions of the unit’s operations	STATUS
are also displayed on the front panel
display. In addition, the display can be
switched to check the unit’s
operating status while playing a source
by pressing the STATUS button.	(Main unit)

eUsing the dimmer function

•Use this to change the brightness of the display.

The display brightness changes in four steps (bright, medium, dim and off) by pressing the DIMMER button repeatedly.

The brightness changes in 3 steps each time the button is pressed, and finally the display turns off.

DIMMER

(Main unit) (Remote control unit)

[6] Switching the surround speakers

1

The surround speakers switch as

1 shown below each time the SPEAKER button is pressed.

SURROUND A SURROUND B

(Main unit) (Remote control unit)

SURROUND A+B

(Remote control unit)

•Select “SOURCE” using the video select button.

•Switch the program source to the component connected to the video input.

This operation is possible when the setting for using both surround speakers A and B is made at “Speaker Configuration” in the System Setup Menu.

35