Denon DN-HC4500

ENGLISH

7TRIM

For instructions on the trim function, refer to the

manual of the DN-D4000/D4500/BU4500. NOTE:

If the setting made at the “CD Mode Sel”

presetting does not correspond to what is

actually connected, the unit may not operate

properly.

8PRESET

•This function is only valid when the “PC” source is selected.

(When the DN-D4000/D4500/BU4500 is connected, the corresponding preset operation is performed.)

•The DN-HC4500 is equipped with a preset function allowing users to store and recall the devices’

operation modes. The function includes the items and values described below.

1. Preset mode

qPress and hold in the PRESET button for at least 1 second to enter the preset mode.

wUse the PARAMETERS knob to select the preset item.

eSelect the item and press the PARAMETERS knob to set the preset item to be changed.

rNext, turn the PARAMETERS knob. The preset data is selected.

tSelect the data and press the PARAMETERS knob to set the preset data to be changed.

yTo make multiple presettings, repeat steps w~ t.

uThe preset mode is turned off when the PRESET button is pressed.

2. Preset items and data

The “*” mark next to the data indicates the default value.

(1) USB Mode Sel: HC4500 MIDI*

Selects the USB communications mode.

The DN-HC4500 uses unique MIDI specifications.

(2) CD Model Sel: DN-D4500* / DN-D4000

Select the name of the model to be connected to the DRIVE terminal and controlled.

The BU4500 is the same as the DN-D4500’s drive, so the PRESET setting is “DN-D4500”.

(3) Audio Fs Sel: 44.1k* / 48k / 96k / Auto

44.1 kHz: The sampling frequency (Fs) is fixed at 44.1 kHz, regardless of the data sent from the

PC.

48 kHz: The sampling frequency (Fs) is fixed at 48 kHz, regardless of the data sent from the PC.

96 kHz: The sampling frequency (Fs) is fixed at 96 kHz, regardless of the data sent from the PC.

AUTO: The sampling frequency (Fs) switches automatically according to the data sent from the

PC.

qTo set “Fs”, press PARAMETERS.

“OK to CHANGE?Ø” is displayed on the character display.

wPush the PARAMETERS knob again.

eAfter the sampling frequency is changed, “Audio Fs Sel” is displayed.

(4) Unit No. Set: 1 to 15 / ALL*

Sets the device’s unit number.

For example, when two devices are connected to a PC, set one device to “No. 2” or the like.

(5) MIDI CH Set: 1&2* / 3&4 / 5&6

Sets the MIDI channel.

(6) JOG Pulse Sel: 1480* / 740 / 555 / 370 count/cycle

Selects the number of pulses output per one revolution of the jog wheel.

(7) FaderIn Mode: 1-PLAY/CUE / 2-PLAY / CUE

(8) X-CONT XFD: OFF / ON*

Sets whether to enable or disable X-control input signal cross fader input.

(9) Preset Init.: Set all the preset data back to the factory defaults.

qTo clear the PRESET data, push the PARAMETERS knob.

“Preset Init” flashes on the character display.

wPush the PARAMETERS knob again.

“Push to ExeØ” is displayed on the character display.

ePush the PARAMETERS knob again.

“OK to CHANGE?Ø” is displayed on the character display.

rOnce clearing is completed, “Completed!” is displayed.