Fireplace Installation
Continued
Removing Louver Panels
Remove top and bottom louver panels by simultaneously pulling both top end spring latches toward center of appliance until they are disengaged from locating holes (see Figure 28). Repeat for bottom spring latches and pull louvers outward. To install or replace items removed, simply reverse procedures above.
Louver
Panel
Spring
Latch
Figure 28 - Removing Louver Panel
Spring Clips
1. Lift Up Panel
at Lower Rail
Removing/Replacing Glass Door
WARNING: Handle glass door panel with care. Do not strike, slam or otherwise abuse glass. Do not operate fire- place with glass door removed, cracked or broken.
If replacement of glass is necessary, the entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape remaining fragments onto frame.
Glass Panel
Frame Rail
Figure 29 - Removing/Replacing Glass
Door
Locating
Hole
1. | Placing a screw driver or your finger tips |
| into gap between lower glass panel rail |
| and bottom face frame, lift glass door as- |
| sembly until door pins clear locating holes |
| in bottom face frame (see Figure 29). |
2. | Swing bottom glass panel assembly out |
| until door pins on lower rail clear bottom |
| face frame (see Figure 30). |
2. Swing Out
Panel
3. Lower
Panel Out
Glass Panel
Frame Rail
Door Pin
3. | Lower door down until upper door pins are |
| free of locating holes in spring clips and |
| place in a safe area. |
4. | Replace glass panel in reverse order by |
| inserting top door pins into spring clips, |
| lifting up at lower frame rail and locating |
| bottom pins in holes on lower face frame. |
Figure 30 - Removing/Replacing Glass
Door
18 | www.desatech.com |
