Desa CB36N Plastic Mounting Clips, Installing and Activating the Remote Receiver, Ignition

INSTALLING OPTIONAL CONTROLS

Continued

4.Connect one wire from receiver to male connector on high limit harness and one to “TH” on control valve (see Figure 14, page 12).

5.Locate two plastic mounting clips provided with kit.

6.Use clips to mount receiver on remote mounting bracket as shown in Figure 16.

Plastic Mounting

Clips

REMOTE ON OFF

Towards Front

Remote Receiver

Figure 16 - Mounting Remote Receiver to

Bracket

Installing 9-Volt Alkaline Battery in Hand-

Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to a 9-volt alkaline battery (not included). Place battery into battery housing (see Figure 17).

3.Replace battery cover onto remote con- trol unit.

Battery

Cover

Terminal

Wires

9-Volt	Remote
Battery
	Control
Battery
	Unit
Housing

Figure 17 - Installing Battery in Hand- Held Control Unit (HRC100 Series)

INSTALLING OPTIONAL WIRELESS REMOTE CONTROL - MODEL WRC (Electronic Ignition)

Installing and Activating the Remote

Receiver

1.Open bottom louver and locate plug re- ceptacle. Plug receptacle is located either on right or left side of cabinet.

2.The WRC model receiver does not require a battery. Receiver can be installed by first plugging short extension cord into fireplace receptacle. Then plug receiver unit into extension cord. Finally plug igni- tion module plug into receiver unit (see Figure 18).

3.Activate remote handset battery by re- moving insulating tab on back of handset (see Figure 19). Battery is included pre- installed.

4.Once battery is activated unit is ready to use.

5.Replace bottom louver panel.

Fireplace	Remote
Receptacle	Control
	Receiver

	Ignition
Extension Cord	Module
	Plug

Figure 18 - Installing WRC Remote Receiver

Battery Cover

12 Volt Battery Back of Handset

Pull to

Remove

Insulation

Tab

Figure 19 - Installing Battery into Back of

Handset

117437-01D www.desatech.com 13