Desa E32, VE36, VE32 Servicing Control Panel, Detaching Power Harnesses, RemovingControl Panel

Models: E32, VE36, VE32 E36(L)(B)(H)

1 26
Download 26 pages 15.92 Kb
Page 14
Image 14
Servicing Control Panel

14

ELECTRIC FIREPLACE

 

INSTALLATION INSTRUCTIONS

 

Models: (V)E32L, (V)E32LB, (V)E32LH, (V)E32LBH

 

(V)E36L, (V)E36LB, (V)E36LH and (V)E36LBH

Servicing Control Panel

The control panel can be serviced from inside the unit by removing the control cover on the inside of the firebox, follow steps 3 through 5 under Optional Heater Accessory, page 9.

If the control assembly needs complete replacement, proceed to remove as follows:

1. Remove the glass doors (if equipped). See Optional Glass Doors, on page 7.

2.Remove retaining screws holding the screen rods and pull screen assemblies out from the locating hole on the inside top of each screen pocket (see Figure 16, page 8).

3.Remove 2 Phillips screws holding the control cover to the control panel inside the firebox (see Figure 20, page 9).

4.Slide the control cover to the right and swing out the locking tabs from the notched openings on top. See detail on Figure 20, page 9.

5.Pop out the bushings on the control cover and slip the power harnesses free from the control cover. See Figure 30.

6.Remove the magnet assemblies, discharge deflector and control door. See Removing/Replacing Control Door, page 13.

7.Tilt entire control assembly forward until lower flange clears the upper door rail then slide assembly down the space between the front face and the firebox mount (see detail Figure 31).

8.Angle control panel out through the opening (see Figure 31).

9.Follow these instructions in reverse order to reassemble the control panel.

Note: Be certain that all wires, harnesses and bushings are returned to their normal position and free of damage before reconnecting the supply power to the appliance.

CAUTION: Note the location of all wires prior to disconnecting. Be sure to reconnect wires to their proper locations. If you are unsure about the proper wire locations, follow the wiring diagram Figure 28, on page 12.

BUSHINGS

CONTROL

COVER

POWER

HARNESSES

Figure 30 - Detaching Power Harnesses

PANEL

SCREWS

POWER

HARNESSES

CONTROL

PANEL

CONTROL

PANEL

Figure 31 –Removing Control Panel

For more information, visit www.desatech.com

111076-01C

Page 14
Image 14
Desa E32, VE36, VE32 Servicing Control Panel, Detaching Power Harnesses, RemovingControl Panel, Electric Fireplace