Further Accessing Imaging Unit For Replacement
The imaging unit can be removed from inside the firebox for servicing as follows:
1.Remove 4 Hex screws on the lower louver panel and detach the louver assembly from the front face. See Figure 41, page 18.
2.Rotate the top edge of lower frame rail inward and lift upward until locking tabs detach from the front face (see Figure 42).
3.Slide the entire imaging forward and lift out through the front opening (see Figure 43).
Note: An additional 3 feet of harness is tucked behind the imager to permit removal without disconnecting any control wiring.
Note: If full replacement of the imager is necessary, the wiring harnesses must be disconnected and the new harnesses reconnected at the control panel. For proper connection, follow the wiring diagram show in Figure 28, on page 12.
ELECTRIC FIREPLACE 19 INSTALLATION INSTRUCTIONS
Models: (V)E32L, (V)E32LB, (V)E32LH, (V)E32LBH (V)E36L, (V)E36LB, (V)E36LH and (V)E36LBH
IMAGING UNIT
Figure 43 - Removing Imaging Unit
LOCKING TAB
UPPER RAIL
REPLACEMENT PARTS
Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty.
PARTS UNDER WARRANTY
Contact authorized dealers of this product. If they can’t supply original replacement part(s), call DESA Technical Service Department at
When calling DESA, have ready:
●your name
●your address
●model and serial numbers of your fireplace
●how fireplace was malfunctioning
●type of accessories
●purchase date
Figure 42 - Removing Lower Frame Rail
Further Technical Service
You may have further questions about installation, operation or troubleshooting. If so, contact DESA Technical Service Department at
You can also visit DESA technical service’s web site at www.desatech.com.
PARTS NOT UNDER WARRANTY
Contact authorized dealers of this product. If they can’t supply original replacement part(s), call DESA Technical Service Department at
When calling DESA, have ready:
●your name
●your address
For more information, visit www.desatech.com