Desa E32, VE36, VE32 Electric Fireplace Installation Instructions, Removing Viewing Screen

16 ELECTRIC FIREPLACE INSTALLATION INSTRUCTIONS

Models: (V)E32L, (V)E32LB, (V)E32LH, (V)E32LBH (V)E36L, (V)E36LB, (V)E36LH and (V)E36LBH

VIEWING SCREEN

Figure 35 - Removing Viewing Screen

Servicing Fan Blower

If the fan blower requires service, it may be removed as follows:

1.Remove the 3 light bulbs from the lamp fixtures (see Replacing Light Bulbs, page 13).

2.Disconnect the two 1/4" blade connectors at the motor unit.

3.Remove 4 hex nuts and washers located on the blower mount at the base of the cabinet. See Figure 37.

4.Lift entire fan assembly off its mounts and tilt it out of the unit.

5.Remove the 4 nut and bolt combinations from the fan housing.

6.Remount the new fan to the blower mount in reverse order.

7.Slide the blower assembly with spacers over the mounting lugs and replace the washer and nut at each lug. Do not over tighten.

Note: The wire connectors for the fan motor are non-polarized and may be connected to either of the 2 terminals for proper operation.

BASE COVER

Figure 36 – Removing Base Cover

WASHER

M6 HEX NUT

SPACER

SLEEVE

FAN

ASSEMBLY

Figure 37 - Removing Fan Assembly

For more information, visit www.desatech.com

111076-01C