DeWalt DS200 Contact, Full One Year Warranty, Patent Notification, English, Led Display Codes

English

Contact

If you have any questions or comments about this product, call us toll free at 1-800-4- DEWALT (1-800-433-9258); or visit www.dewalt.com. To answer any specific monitoring questions call DEWALT customer service or refer to the monitoring service contract for additional contact phone numbers.

Full One Year Warranty

The DEWALT Jobsite Security Portable Alarm System is warranted for one year from date of purchase. We will repair, without charge, any defects due to faulty materials or work- manship. For warranty repair information, visit www.dewalt.com or call 1-800-4-DEWALT (1-800-433-9258). This warranty does not apply to accessories or damage caused where repairs have been made or attempted by others. This warranty gives you specific legal rights and you may have other rights which vary in certain states or provinces.

FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call 1-800-4-DEWALT for a free replacement. See the beginning of this manual for a list of warnings on the Base Unit and Key Chain Remote.

Patent Notification

Manufactured under one or more of the following patents.

5,587,701 5,777,551 6,441,731

5,850,180 6,049,273 Other patents may be pending.

LED DISPLAY CODES

LED	SOLID	BLINKING	OFF
POWER	Primary power	• Primary power supply	No unit power
	source is present	missing (steady flashes);	and no battery
		• Low battery (series of two	power
		flashes); or
		• Standby state (one flash
		every 5 seconds)
ARMED	System is armed	On an exit or entry delay	System is
			disarmed
CELL	Cellular signal	Cellular signal	Little or no
	is strong	is weak	cellular signal
CALL	Call is complete	Call is in progress	No activity
	(will remain solid
	for 30 seconds)

DESCRIPTION OF FAULT CODES

Fault Code	Fault Display	Description	Action
Power	Primary Power	No power to	Check power supply
	Lost Base	Base Unit
DevPower	Primary Power Lost	No battery power	Change battery, reset
	Device #	in device
BaseLowBatt	Base	Base Unit	Plug in power supply
	Low Battery	battery low	to recharge battery
DevLowBatt	Low Battery	Device battery	Change battery, reset
	Device #	low
WeakSig	Weak Signal	Transmission signal	Check for interference;
	Device #	from device is weak	move device
Unsecured	Unsecured	Device has	Check for intrusion;
	Device #	been tripped	re-secure device
NoCheckIn	No Check In	Device check-in	Check for interference;
	Device #	messages have not	move device
		been received
Tamper	Tamper	Device has been	Close device or
		opened or damaged	replace if damaged
BaseBadBatt	Bad Battery	Base Unit battery has	Needs to be repaired
	Base	dropped below the	at DEWALT authorized
		voltage limit	service center
CellRadio	Cell Radio	Cellular radio	Move Base Unit to
	Fault	signal is lost	a location where
		or scrambled	CELL light is solid;
			call Customer Service
			if problem persists
Receiver	Receiver Fault	2-way transmission	Call customer service
	Device #	of device is lost	to test system for issues
NetControl	Base Network	Base RF processor	Internal check; will clear
	Control	communications	itself; call Customer Service
			if problem persists

21