4.There are two indications that the system is armed. First, the ARMED light on the upper right of the keypad will be on. Second, the Armed screen will be displayed.
USING THE KEY CHAIN REMOTE
The Key Chain Remote can be used for
IMPORTANT: Arming the system introduces the risk of setting a FALSE ALARM. When a device is tripped (i.e., a door is opened), immediately disarm the system. If unable to dis- arm before the monitoring system is notified, call DEWALT customer service to report a false alarm. If the authorities have been dispatched, a fee may be associated with the false alarm. This fee is the responsibility of the owner of the system.
CAUTION: LOUD NOISE. Using the Key Chain Remote to arm the system will cause a brief loud noise that may startle any persons near the Base Unit.
1.To arm the system, press the arm 
button on the left side of the Key Chain Remote.
2.For 60 seconds, the screen will display the following message indicating that the system is arming:
During arming, the Base Unit will first make a quick loud siren noise to indicate that the signal from the Key Chain Remote was received and the system is arming. The Base Unit will chime for 60 seconds. Finally, the Base Unit will make two quick loud siren noises to indicate that the system is armed.
To disarm for any reason before arming is complete, such as the need to
the premises, press the disarm 
button on the right side of the Key Chain Remote or select DISARM and enter either the master code or a user code.
NOTE: If Arming with Faults is displayed and a warning chime is heard, there is a serious issue that could leave the site unsecured. You may arm over a fault (force arm); however, it is highly recommended that the issue be corrected prior to arming. For further information on fault codes, see Faults.
3.There are three indications that the system is armed. First, there will be a quick loud siren noise. Second, the ARMED light on the unit will be on. Third, the Armed; Enter Code screen will be displayed.
ARMING AUTOMATICALLY
This feature can be useful to ensure the system can be properly armed if arming cannot be initiated by the master user or other users of the system. Once a time is set, the system will activate at the same time each day.
CAUTION: LOUD NOISE. Enabling the auto arm feature will cause a brief loud noise while arming that may startle any persons near the Base Unit.
To enable the automatic arming feature, be sure that the system is disarmed.
1.Start at the main screen.
2.Select MENU or press MAIN MENU on the keypad.
3.Using the keypad, enter the master code.
4.Use the up and down arrows to scroll through the menu until the System Settings screen is displayed. Select OK.
5.Use the up and down arrows to scroll through the menu until the Auto Arm ON/OFF screen is displayed. Select OK.
6.When the following screen appears, select CHANGE. The CHANGE button toggles between on and off.
7.When the automatic arming is enabled, the Autoarm ON screen will appear. Select EXIT.
8.To set the time, select OK.
9.Using the numbers on the keypad, choose a time for the system to be automatically armed, changing hours first, then minutes.
The character that is being changed will be underlined. To move back a character, use the down arrow. To move forward a character, use the up arrow.
Basic Operations
8
