DeWalt DS200 Alarm Codes, Cell Phone Text Message Codes, Default E-mail, Meaning, Action Required

English

ALARM CODES

Display	Event
Unsecured device x txt	Unsecured
Tampered device x txt	Tamper
Unsecured base motion	Internal PIR trip
Unsecured base vibration	Internal vibration trip
System alarm	Start of alarm cycle (8 min.)

ALPHA/NUMERIC CHART

KEY		# of presses
PAD	1		2	3	4	5
1	1		1	1	1	1
2	2		A	B	C	2
3	3		D	E	F	3
4	4		G	H	I	4
5	5		J	K	L	5
6	6		M	N	O	6
7	7		P	Q	R	S
8	8		T	U	V	8
9	9		W	X	Y	Z
0	0		space	.	space	.

CELL PHONE TEXT MESSAGE CODES

NOTE: The subject line of the E-mail/ Text Message identifies the name of the Base Unit either alarming or under test.

	Default E-mail/
	Text Msg Notice	Meaning	Action Required
Sitelock Event: Auto periodic		This is a weekly test	None. This is a notification
test, Sensor # 000		performed between the	that the system is operating
		DS100 and Sitelock to	properly.
		assure that the unit and
		system are working properly.
		Sensor 000 is the Base Unit.
Sitelock Event: Manual		User has performed a	None. This is a notification
test, Sensor # 080		cell radio test. Sensor	that the system is operating
or # 000		# 080 or # 000 indicates	properly.
		that this is a manual test.
Sitelock Event: Low system		The Base Unit battery	If AC power is not applied,
battery, Sensor # 000		voltage is too low. After	plug in the unit. If AC power
		1 hour, the unit will	is applied, the battery is failing
		become disarmed and go	and needs to be replaced
		into standby mode.	at a DEWALT authorized
			service center.
Sitelock Event: Burglary		Unit is armed and an	Contact the police and
alarm open, Sensor # 000		unauthorized intruder has	provide the appropriate
		been detected by the	information to notify them
		Base Unit motion or	of an intrusion.
		vibration sensor.
Sitelock Event: Burglary		Unit is armed and an	Contact the police and
alarm open, Sensor # XXX		unauthorized intruder has	provide the appropriate
		been detected by sensor XXX.	information to notify them
			of an intrusion.

23