Industry Canada
•NOTICE: this equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is confirmed by the registration number. The abbrevia- tion, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment.
•This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements documents. The Department does not guarantee the equipment will operate to the user’s satisfaction.
•The RINGER EQUIVALENCE NUMBER (REN) for this terminal equipment is noted on the Base Unit label. The REN assigned to each terminal equipment provides an indi- cation of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence. Numbers of all the devices does not exceed five (5.0).
•Before installing this equipment, users should ensure that it is permissible to be con- nected to the facilities of the local telecommunications company. The equipment must be installed using an acceptable method of connection.
•The customer should be aware that compliance with the above conditions may not pre- vent the degradation of service in some situations.
•Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the user to this equipment or equip- ment malfunctions may give the telecommunications company cause to request the user to disconnect the equipment.
•Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
•CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.
•The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to pre- vent overloading. The termination on a loop may consist of any combination of devices subject only to the requirement that the total of the LNs of all the devices does not exceed 100.
IC:
IC:
Warnings
For your convenience and safety, the following warning labels are on the Base Unit and Key Chain Remote:
DS100 BASE UNIT
•To reduce the risk of injury, user must read and understand Instruction Manual.
•Use only with DEWALT authorized power sources designated for this product.
•Not for personal protection.
•Contains
DS200 KEY CHAIN REMOTE
• To reduce the risk of injury, user must read and understand Instruction Manual.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call
Introduction
v
