system’s signal strength on the INSTALLATION screen. Refer to the “Installation” section found later in this chapter.
Things to do on the SETUP MENU
Current settings overview
An overview of the current settings can be reviewed without having to access each associated screen.
Scheduler
Your digital satellite receiver is equipped with a SCHEDULER that allows up to 32 events to be programmed. You can use the SCHEDULER feature along with
your VCR to record events in your absence. The SCHEDULER can be used to automatically tune to a program at a specific date and time or at a specific time on a repeating basis.
You may choose to also program your VCR’s timer to achieve unattended recording. If doing so, program the start and end times of the event on your VCR’s scheduler. However, when specifying the channel, use the output channel of your digital satellite receiver. This would be channel 3 or channel 4, depending on the setting of the switch on the rear of the digital satellite receiver.
The SCHEDULER screen
Things to do on the SCHEDULER screen
The EVENT TIMER screen displays up to seven rows of events. You can use the 
key to scroll down, through the events.
There are multiple settings for the On column: a check mark ( ü) to indicate you have chose that you want to view that event.
Editing an event
The “Events” portion of the screen displays up to seven previously scheduled events at any one time. If there are more than seven events already scheduled, you may use the 
key to scroll down, or the 
key to page through the additional events. You can tell if these additional events can be viewed by the presence of a small arrow at the top or bottom of the event list.
Once you have highlighted the event you wish to set or edit, press 
. You will be prompted with a
inadvertently pressed 
on an event but do not wish to make any changes, select Cancel.
After choosing one of the scheduling options a 
and 
, 
and 
.
After specifying a channel, press the 
key or select OK when you are ready to continue.
Next, enter a Start time using the number keys on the remote control, or by using the 
and 
keys. Press 
to continue.
You then must specify whether the time you entered is “AM” or “PM” (or “N” for noon, or “M” for midnight if the time specified is 12:00) using the 
and 
keys. To continue, press 
.
PAGE
