I n s t r u c t i o n s : T V P o w e r , V o l u m e , a n d T V I n p u t

2.Enter the search code. Refer to the table below and use the number keys on your remote control to enter the appropriate code.

To Test:

TV power, volume,

TV input

A/V receiver power,

A/V receiver volume

 

and muting

 

volume, and mute

and mute only

 

 

 

 

 

Enter:

0999

0999

1999

1999

 

 

 

 

 

After you press the fourth digit of the code, the red light on the end of the remote control will flash twice, then remain on.

3.Test the remote control. Point the remote control at the TV or A/V stereo system. Press CHAN UP. Did the TV or A/V stereo system turn off? If not, wait two or three seconds, then press CHAN UP again. Continue doing this until the TV or A/V receiver responds.

When the TV or A/V receiver does turn off, press ENTER to select the current code. The red light at the end of the remote control will flash three times to indicate that the remote control is properly coded to control your device.

When the red light on the end of the remote control turns off, you have reached the end

7

of the available codes.

 

Unfortunately, due to the great variety of TVs and A/V receivers, some makes and models are not compatible with your HD DVR’s remote control. If you reach the end of the available codes without finding a code that works with your device, you will need to use your TV or A/V receiver’s remote to turn it on and off, and control the volume.

113