(Optional) Connect the Coaxial RF cable from your
Connect the Coaxial RF cables from your satellite dish antenna to the jacks labeled
Satellite In 1 and Satellite In 2 on the back of the HD DVR. You can connect either cable to either jack.
Connect the Component Video cable from the HD DVR’s Component Output jacks to the Component Input jacks on your HDTV. Make note of the input you use for video on your HDTV, and use the same input for audio. Alternately, if your HDTV has a DVI Input jack, you can use the
Connect just the red and white ends of the Composite A/V cable from the HD DVR’s L/R Audio Out jacks to your HDTV’s L/R Audio In jacks for stereo audio. Do not connect the yellow end of the Composite A/V cable. Use the same input on your HDTV for audio that you used for video in step .
Insert the access card that came with your HD DVR into the Access Card slot on the front panel as shown in the diagram to the right (with the gold chip down). Stop when the card makes contact with the back of the slot. To receive DIRECTV service, you must insert the card correctly and activate it. Activation is covered in the next chapter.
Connect the phone cord. (For more about the phone connection, see page 3.)
Plug in the power cord. After you see the Welcome screen, you can begin Guided
Setup, starting on page 22. If you do not see the Welcome screen, make sure the correct input is selected on your
S e t u p O p t i o n s
Your HD DVR will work if you | 1 |
| |
connect only one cable to the |
|
“Satellite In 1” jack, but it will not have |
|
dual tuner functionality. See page 6 for |
|
more information about dual tuner. |
|
The Access Card slot is behind a small door.
17