Chapter 10
The Recover Button
1Turn on the other receiver and display the System Info screen as described in the user’s guide for information on how to display the screen).
Write the address:
2Press and hold AUX until all the other mode buttons light up, and then let go of the button. AUX flashes.
3Press the 3 button.
4Use the NUMBER PAD to enter the address you wrote in step 1.
5Press POUND (#). AUX blinks three times.
6Press RECORD to make sure the address and the remote matches the address on the receiver.
THE RECOVER BUTTON
Use RECOVER if you suddenly have a snowy, blue, or black screen on your TV and cannot get the picture back from your satellite receiver. When you press RECOVER as described below, the remote control sends commands to your TV to change channels or video inputs to get back to watching satellite programming. This procedure works only if you have accidentally changed the TV channel or video input. It does not recover lost satellite signal (See Troubleshooting on page 116 for information on solving problems).
Note: The remote must be programmed to control the TV (and VCR, if applicable) for RECOVER to work as described.
Note: RECOVER will first try to tune your TV to channel 3, then channel 4, and then other video inputs with each press of RECOVER. You may need to press RECOVER up to 30 times to recover your satellite TV video. If RECOVER is programmed to a specific channel (see page 83), RECOVER will tune the TV to the specific channel (for example, channel 60).
82
