DKS Enterprises 6050, 6100 SECTION 1 - INSTALLATION, 1.1 Operator Position, 34”, 12”, 43”, opening 90°, convenience open or, For pad or post mount, standard with the gate

SECTION 1 - INSTALLATION

Prior to beginning the installation of the swing gate operator, we suggest that you become familiar with the instructions, illustrations, and wiring guide-lines in this manual. This will help insure that your installation is performed in an efficient and professional manner.

The proper installation of the vehicular swing gate operator is an extremely important and integral part of the overall access control system. Check all local building ordinances and building codes prior to installing this operator. Be sure your installation is in compliance with local codes.

1.1 Operator Position			6100 Convenience Open Operators ONLY:
		For pad or post mount ,	Gate		Output shaft is offset 1” from center.
					The open gate will be 1” closer on one
		convenience open or	Closed		side of the operator OR 1” further away
		standard with the gate		90°	on opposite side of operator as shown.
		opening 90°.		Open Gate
	See 1.9 for gate’s opening wider than 90°.						3”
		An imaginary straight line drawn	12”			Operator
	Bracket					Output	7.25”
		from the closed gate bracket			Centerline	Shaft
		through the open gate bracket
	Gate	MUST intersect the					6.75”
		operator output shaft.
			12”
				43”
							5”
34”
				Open Gate
	GateClosed		GateClosed
				90°
	90°					Note: 2” thick gate Illustrated.
	Open Gate
		3”		4”
		21.25”
12”
	Convenience Open			Operator
		6100 Cover
				Output
	(See above detail)
				Shaft
		26”
	Standard Operator						35”
		Cover
		43”				Minimum distance
						required for arm
						clearance in the
		Note: The operator can be placed further away from the open gate than				open position.
		shown as long as the imaginary straight line drawn from the closed gate
		bracket through the open gate bracket intersects the operator output shaft.

10 6050-065-L-11-08