DKS Enterprises 6050, 6100 3.3 DIP-SwitchSW 2 Settings, SW 2 (Bottom 8 Switches)

3.3 DIP-Switch SW 2 Settings

			SW 2 (Bottom 8 Switches)
Switch	Function	Setting	Description
	Primary	OFF	Opening direction of arm using OFF setting.
			Gate opens counter-clockwise.
1	Operator
	Opening
	Direction	ON	Opening direction of arm using ON setting.
			Gate opens clockwise.
	Secondary	OFF	Opening direction of arm using OFF setting.
			Gate opens counter-clockwise.
	Operator
2
	Opening
			Opening direction of arm using ON setting.
	Direction	ON
			Gate opens clockwise.
3	Seft-Test	OFF	Normal operation.
		ON	Self-test mode. Operator MUST be disconnected from gate to run self test.
			Switch is OFF when both primary and secondary operator motors are powered
		OFF	from main terminals 4 and 5. Applies to operators originally manufactured with
4	Motor Control		4501, Rev O boards or lower).
			Switch is ON when secondary operator motor is powered from the secondary
		ON
			motor terminals. Applies to operators manufactured with 4501, Rev P boards and
			higher, and all 4502 boards.
5	Reverse Loop	OFF	Terminal 15 is a normal Reverse input.
	Shadow Loop	ON	Terminal 15 is a Shadow input. Gate will NOT stop during the close cycle.
6	Gate Overlap	OFF	Primary and secondary operators start at the same time.
		ON	Secondary operator starts 1-2 seconds prior to the primary operator.
7	Not Used	OFF	Leave in the OFF position.
8	Not Used	OFF	Leave in the OFF position.

Switch 1 Sets direction of the primary operator so that the operator cycles open upon initial power up and open command. If the operator begins to cycle close upon initial power up and open command, turn power off and change the setting on this switch.

Switch 2 Sets direction of the secondary operator so that the operator cycles open upon initial power up and open command. If the operator begins to cycle close upon initial power up and open command, turn power off and change the setting on this switch.

Switch 3 This switch is a self-test feature that checks various functions of the circuit board and is used for bench test only.

Do not run this test with the operator connected to the gate.

Switch 4 This switch applies high voltage motor power to the secondary operator motor terminal located at the top of the board. If a primary / secondary system is in use, this switch should be ON and the secondary motor wires connected to the secondary operator motor terminal. For single gate applications, this switch can be turned OFF.

Switch 5 This switch sets the input at Terminal 15 to act as a normal reverse input or to act as a shadow input. A shadow input will only hold the gate operator in the open position once it is in the full open position. A shadow input will not reverse the direction of the gate operator once it begins its close cycle.

Switch 6 Used in primary / secondary applications, turning this switch ON will cause the start of the primary operator to be delayed 1-2 seconds. This allows the secondary gate to reach the full closed position prior to the primary gate, which is desirable when the gates are constructed with an overlap or if a magnetic lock is used to secure the gates.

Switches 7 and 8 Spare switches, leave in the OFF position.

24 6050-065-L-11-08