DKS Enterprises 6050, 6100 SECTION 3 - ADJUSTMENTS, 3.1 4502 Circuit Board Adjustments, Contact, Dry Relay, DIP-Switches, Auto-CloseTimer

SECTION 3 - ADJUSTMENTS

The switch settings and adjustments in this chapter should be made after your installation and wiring to the operator(s) is complete. Whenever any of the programming switches on the circuit board are changed, power must be shut-off, and then turned back on for the new setting to take effect.

3.1 4502 Circuit Board Adjustments

Power LED indicates that low voltage power is applied to the circuit board. Input LEDs should be OFF and will only illuminate when an input is activated. Pulse 1 and 2 LEDs will blink as the operator(s) are running. They can be either ON or OFF when the operator(s) are stopped. One pulse LED for each operator used (Primary/Secondary). Tracker LEDs will flash as operator data is

sent to the access				Board											Board
controller (DoorKing
models 1833, 1835,	1			Power											Ground
1837 or 1838 only).	2																			EXIT
	3
	4
	5
	6															Loop
	7																LED
	8
	9
				Pulse 1 LED Primary Operator
	10
					Pulse 2		LED	Secondary		Operator									Loop Detector
	11	nIputLEDs		654321		ON													9410	SHADOWREVERSE
														LED
	15
	12
	13
	14												Power
					8 7
	16
					SW 1													Loop		SHADOW
	18				7654321	ON			Tracker								LED
	17		NC																	OUTPUT
			NO		8						LEDs
	19				SW 2
	20
												4502							Loop Detector

9409

Dry RelayContact

Dry relay contacts (terminals 16-17) can be set for Normally Open (NO) or Normally Closed (NC) operation by placing the relay shorting bar on the N.O. or N.C. pins respectively.

DIP-Switches

	2 1	ON
Set the DIP-switches	5 4 3
on the circuit board to	6
the desired setting.	8 7
See switch-setting	SW 1
charts on next 2 pages.	2 1	ON
	8 7 6 5 4 3

SW 2

Auto-Close Timer

	2 1		ON
Auto-close timer (when	4 3
	6 5
turned on) SW 1, switch 4.
	8 7
	SW 1
Adjust from 1 second
(full counter clockwise) to
approximately 23 seconds
(full clockwise).	1	23

22 6050-065-L-11-08