Owner’s Manual
Operation
Operation
Now that you have completed the initial setup and configuration of the Model 950, it is simple to operate and enjoy. Reading the following section will help you get the maximum pleasure from your new equipment. Make sure the unit is plugged in and the Main Power switch on the rear panel of the 950 is in the On position, as outlined in the “System Setup” section.
Direct Operation
In addition to entering settings into the Model 950 using the Menu System, as described in the System Setup section of this manual, many of the controls may be changed directly at any time using the remote control or front panel buttons. To change one of these settings (for example, Channel Trim), simply press the appropriate button on the remote or front panel and use the naviga- tion buttons as required to change the settings.
Power
To turn the Model 950 on and off:
1.Press the front panel Standby Power button to turn on the Model 950, or press the AUD button on the remote control.
The FRONT PANEL DISPLAY will light up and the Standby indicator will turn off.
Alternatively, pressing any of the source selection buttons (DVD, CD, VCR, etc.) on the remote control will turn on the Model 950.
Powering the unit on this way sets the Model 950 to the selected source and sets control of the remote control to that source device. To control the Model 950, press the AUD button on the remote.
2.Press the Standby Power button on the front panel again or press the POWER button on the remote control to return the Model 950 to Standby mode.
The FRONT PANEL DISPLAY will go out and the Standby Indicator will light up.
Note that remote needs to be set to control the 950 (by pressing the AUD button) before the POWER button will turn off the unit.
Selecting a Source
Before you can listen to any input, you must first select that input as the source. This tells the Model 950 which input source to send out to the speakers and monitor.
To select an input source:
1.Press one of the Source buttons (DVD, CD, VCR, etc.) on the remote control or press the or SOURCE buttons on the front panel of the Model 950 to cycle through the input sources.
The Front Panel Display and the OSD will show the source you have selected. The settings displayed will be those that you set in the Input Configuration menu during initial setup. An example is shown below:
DVD | DOLBY EX |
OPTICAL1 | |
|
|
2.Press AUX 1 or AUX 2 on the remote to select one of the auxiliary audio input sources
NOTE: When a video input has been selected as the current source, its video signal will appear on the connected television or monitor. Changing the selected input to an
Selecting a Source Input
When you select a source from the 950’s remote or front panel, the input selected during Input Configuration is automatically used as the source input. You can select another input by following the procedure below.
To select a source input:
1.Press the DIGITAL button on the remote control or the DIGITAL SELECT button on the front panel.
The next input in order will be chosen by the 950. Your selection will appear on the Front Panel Display and OSD.
DVD | DOLBY D |
OPTICAL1 | 00dB |
|
|
The input choices will display in the following order:
ANALOGOPTICAL1OPTICAL2OPTICAL3 OPTICAL4COAXIAL1COAXIAL2
2.Press the same button repeatedly to cycle through inputs.
Your selection becomes the new default input for that source.
DVD | DOLBY D |
COAXIAL1 | 00dB |
|
|
Volume Control
Use this control to adjust the volume level of all currently connected speakers.
To adjust the main volume level:
Press the or VOL buttons on the remote or turn the VOLUME knob on the front panel to adjust the volume of the Model 950.
You can adjust the main volume level from
DVD | DOLBY EX |
OPTICAL1 | 00dB |
|
|
Note that the main volume control does not affect the volume level in the second zone.
30
Outlaw Audio